4 Meters 2000A Car Battery Jump Leads Booster Cables Emergency Jump Cable Clamp For Car Van Truck Car

[Product name]: 2000ABattery Jump Cable
[Product packaging]: PVC bag
[Product color]: red+black
[Product size]: Wire 3.7m , total long is 4m
[Material]: copper

[Operation Steps]:

1. Connect a red clamp head (+) of the cable to the positive terminal of the dead battery(Which car battery is no power).

2. Connect the other red clamp head (+) of the cable to the positive terminal of the battery(Which car battery with power).

3. Connect a black clamp head (-) of the cable to the negative pole of the battery(Which car battery with power).

4. Connect the other black clip head of the cable with the engine housing or car body or directly grounded(Which car battery is no power).

5. When starting, please complete the operation immediately, and there should be 10 seconds of cooling time between two adjacent starts.

6. Unload the cable wire in the reverse order of installation.

[Precautions]

1. Operate in strict accordance with the operation steps.

2. Check the marked voltage of the two batteries to ensure that the voltage of the two batteries is the same.

3. Turn off all loads on the vehicle, shift to neutral, pull the handbrake and start the engine. Smoking is prohibited near the vehicle.

4. If the car battery has frozen, it is forbidden to start, otherwise it may cause explosion.

5. Please ensure that the battery wiring polarity is correct.

6. During operation, the vehicle shall not contact with other vehicles.

7. The battery will produce explosive gas! Please wear eye protection when installing cable.

8. If the acid substance in the battery leaks accidentally and splashes into the skin or eyes, please immediately wash it with plenty of water, and then ask a doctor for help.